NOTE: The Canadian Health Protection Branch has
issued a Medical Device License (#28294) to SOTA Instruments Inc.
for The Magnetic Pulser. The MPG is classified as a Class II Medical
Device, allowing for sale without a Medical Doctor's prescription.
What is the Magnetic Pulser?
The Magnetic Pulser is a professionally designed quality unit, thoroughly
tested and guaranteed to operate as per the specifications. The Magnetic
Pulser (MPG) is designed to generate an intense (~43,133 Gauss*), momentary (~2.5mS)
pulsed DC magnetic field.
*This 43,133 Gauss measurement is at the inter-coil winding flux. Magnetic flux intensity follows the
inverse square rule - the further you are away from the magnetic core, the faster
the Gauss intensity drops off. At face of Magnetic Coil, the Gauss drops to ~6,000
Gauss.
NOTE: Please do not confuse this unit with permanent/ceramic magnet
therapies, or with the EMR (electro-magnetic radiation) producing units!
Through the principle of induction, this magnetic field creates eddy-currents (tiny
electrical micro-currents) in living organic material that contain an electrolyte
such as saline. Designed to be used with The
Silver Pulser or independently. Targets specific areas.
Unique Features
-
Licensed by the Canadian Health Protection Branch as a Class II Medical Device
(License#: 28294)
-
New Hand-Paddle design. Our pulsing coil has been re-designed into a
custom molded plastic enclosure complete with clear identification of the
Bio-North (-) Magnetic Pole.
-
A unique circuit design allows The Magnetic Pulser to operate without
the use of a Xenon flashtube (as did previous designs) allowing for
maximum power delivery to the coil.
-
Fully Automatic. The MPG4 will automatically charge and discharge - no manual pulsing required.
An internal Digital Counter allows the MPG4 to pulse approximately 5-10 minutes between resets.
-
LED light bar-graph. A light bar-graph consisting of five Green LED lights, illuminates sequentially
giving visual indication of the MPG4 charging up. A dual function Red LED light indicates
either the unit has completed a 5 minute cycle of pulses, or an overload condition has occurred.
-
Operates from an AC-DC Wall Adapter (included), or from a 12 Volt DC source like an automobile battery, appropriate
solar panel, etc.
-
Extremely high magnetic power output. Generates ~32.67 Joules (Watt*Seconds) of energy through the use
of a 600uF, 330VDC Custom Photoflash Capacitor. This then produces ~43,133 Gauss* (~43 kilo Gauss)
magnetic field in the coil. *This 43,133 Gauss measurement is at the inter-coil winding flux. Magnetic flux intensity follows the inverse
square rule - the further you are away from the magnetic core, the faster the
Gauss intensity drops off. At face of Magnetic Coil, the Gauss drops to ~6,000
Gauss.
-
High-Frequency Custom Switch Mode Pulse-Width-Modulated (PWM) power supply allows for fast charges (3.5 seconds)
and a very lightweight unit. Our PWM power supply is a constant-current design.
-
Double-insulated practices used throughout to ensure the greatest electrical safety. Coil is completely enclosed
in a custom-molded plastic Hand Paddle. No exposed wires or leads.
-
New Professional Capacitor. We now have a Professional Custom Strobe type Capacitor designed specifically for
our Magnetic Pulser. The manufacturer rates the capacitor at well over a 30 million (30,000,000) cycles of
operation. Compare this with our earlier version model MPG2 and MPG3 which had a
250,000 cycle life, or to our MPG1 which had a 85,000 cycle life, or even to photoflash based pulsers that have
5,000 - 10,000 life cycle.
-
Very fast charging cycle. Unit fully charges in 3.5 seconds
-
Overload Protection. Should an overload or fault condition occur in the
charging section, a sensor will limit the current, then eventually shutdown the
unit until the fault condition is removed.
-
Bio-North Magnetic Pole Polarity (-) or South-Seeking is clearly identified on
one side of pulsing coil. This gives the user the choice of applying either
Bio-North (-) or Bio-South (+) pole energy to the site.
-
Our Electrical Circuit Boards are GOLD Plated for extreme reliability and workmanship.
-
Compact and lightweight. MPG5 unit weighs 3/4 Lbs. (0.3 Kg.), Magnetic
coil weighs 1 Lb. (0.4 Kg.). Total shipping weight of complete MPG4 with wall
adapter weighs ~3 Lbs. (~1.3 Kg.).
|
